Brochure
DC2DC POWER PRODUCTS
9
DC Motion Sensors
P.I.R. Sensor Motion Switch.
The ePOWER DCMotion is a motion activated switch for 12v and 24v
systems for which a Passive Infra-Red Detector (PIR) is used. Output
loads up to 10A (continuous) can be connected to the EN-DCMOTION
with the added features of over-voltage, under-voltage and over-current
disconnect. For indoor use only. The DCMotion can be used in a number
of situations like yacht or ship engine rooms, undercover truck loading
bays or RV applications.
The ePOWER DCMotion-L is a motion activated LED lamp for 12v and
24v systems for which a Passive Infra-Red Detector (PIR) is used. This unit
has a built in high eciency Power CREE LED (1 Watt). The DCMotion-L
switches the load as soon as motion is detected. If no motion is detected
any more the DCMotion-L switches o with a delay. The delay time can be
set by way of an internal potentiometer. This is done in steps of 5 seconds.
The minimum delay time is 5 seconds and the maximum delay time is
60 seconds. Default is a delay time of about 30 seconds. The load will be
disconnected 30 seconds after the last motion is detected.
Applications
• Recreational vehicles
• Industrial systems
• Service vehicles
• Maritime applications
Model Number EN-DCMOTION EN-DCMOTION-L
Auto Voltage 12VDC / 24VDC
Switch O Time 5 min. *
Power up delay + / – 30 Sec.
Detection Angle 60° H – 60° V
Detection Parameter 5 meters
LED Light No Yes
Weight 30g 107g
Dimension LxWxH 76.5 x 48.5 x 30mm 67 x 50 x 30mm
* Switch O time is adjustable between 1 – 10 min.