Specifications

6
3.4.1 Installation 1 (Cable through the Wall with the Mount Base)
A. Drill the mounting location, using the template sheet (or the bottom of the mount base) as a template.
B. Insert the plastic anchors into the hole which has just drilled.
C. Connect BNC cable and communication lines.
D. Fit the screw holes of the mount base into the plastic anchors.
E. Screw up the M6 torx screws (T-20).
F. Adjust the camera suitably using the pan & tilt function, and fix the camera using the socket set screw, hexagon wrench.
Seal around the stand base tightly using the silicon rubber.
Mount base
Wall
Plastic anchors (4x)
Torx screws (T-20)
M6.0 x 35.0 (4x)
Set screw
M5.0, L=5.0mm
Hexagon wrench
Socket set screw
M5.0, L=5.0mm