Specifications

5.2 Surface mount
Surface mount
base
⑥Mount screws
and ②pipe hole
cap for surface
mount base
Dome base
assembly
④Wrench bolts
for fitting to
surface mount
base
Dome bubble
assembly
L-Wrench
Quick installation guides;
1. Locate the mounting template at the installation position
and drill the ceiling or wall if needed.
2. Place Surface mount base on pre-drilled position and fix it
through
ⓙ
Surface mount holes(x4) by using ⑥Mount screws.
Assemble the cable pipe, otherwise tighten
①
pipe hole cap.
3. Open Dome bubble assembly by loosening
ⓘ
Ring cover
fixing screws(x3)
CAUTION
Extreme care should be taken NOT to scratch the dome
surfaces and to protect it from dirt or dust at any time.
4. ⓕMount holes(x3) for dome base and ⓚhole should be
aligned before fixing Dome base assembly to Surface mount
base by using ④Wrench bolts. And tighten ④wrench bolts
5. Route the power/ video cable to the connecting place.
CAUTION
Care should be taken the cable is NOT to be damaged,
kinked or exposed in the hazardous area.
6. Set the camera’s angle (Pan, Tilt, inclination)
7. Adjust ZOOM/FOCUS by OSD menu or manual
8. Put Dome bubble assembly over Dome camera assembly and
tighten
ⓗ
Ring cover fixing screws(x3) by using
③
L-shape hex
wrench
CAUTION
Tighten enough
ⓗ
Ring cover fixing screws(x3) so that
there should be NO gap between
ⓔ
Lens and
ⓖ
Clear bubble to avoid the light inflow from IR LEDs.
Ceiling or wall
8