Specifications

5.3 Flush mount

⑥Mount screws

Dome base

assembly

Quick installation guides;

1. Locate the mounting template at the installation position

and drill the ceiling or wall if needed.

2. Open Dome bubble assembly by loosening

ⓘ

Ring cover

fixing screws(x3)

CAUTION

Extreme care should be taken NOT to scratch the dome

surfaces and to protect it from dirt or dust at any time.

3. Place Dome base assembly on pre-drilled position and fix it

through

ⓕ

mount holes(x3)

by using ⑥Mount screws.

(Use three screws only out of ⑥Mount screws(4x))

4. Route the power/ video cable to the connecting place.

CAUTION

Care should be taken the cable is NOT to be damaged,

kinked or exposed in the hazardous area.

5. Set the camera’s angle (Pan, Tilt, inclination)

6. Adjust ZOOM/FOCUS by OSD menu or manual

7. Put Dome bubble assembly over Dome camera assembly and

tighten

ⓗ

Ring cover fixing screws(x3) by using ③L-shape hex

wrench

CAUTION

Tighten enough

ⓗ

Ring cover fixing screws(x3) so that

there should be NO gap between

ⓔ

Lens and

ⓖ

Clear bubble to avoid the light inflow from IR LEDs.

Ceiling or wall

Dome bubble

assembly

L-Wrench