Operating instructions

• Change the Application Setting – Motion Detection

Please follow the steps below to enable changes in the motion detection function of the alarm through the network as

necessary.

Set the motion detection:

1. Click on the

Motion Detection button on the left side of the Alarm to enter the „Motion Detection” page.

2. Click and drag the mouse across a targeted zone to draw a red rectangle on the image (coordinates provided

below).

NOTE: You can set more than one targeted zone depending on your requirement.

3. Enables / disables the motion detection function.

4. Set up the signal level.

5. Click on the

Submit button to submit the new setting of the recording.

Description of function keys:

Sensitivity

The sensitivity bar allows you to specify how much movement is required to trigger the

motion detection.

Percentage

Adjusting the percentage allows you to set a requirement on how much of the motion

window must be ﬁlled by movement. For example: If you set this to 50%, then the se-

lected window must be half ﬁlled by a moving object before it triggers motion detection.