Operating instructions

• Change the Application Setting - Alarm - Motion Detection

Please follow the steps below to enable changes in the motion detection function of the alarm through the network

if necessary.

Set the motion detection:

1. Click the

Motion Detection button on the left side of the Alarm to enter the „Alarm - Motion Detection” page.

2. Click and drag the left mouse button to across a targeted zone to draw a red rectangle on the image (coordinates

provided below).

NOTE: You can set more than one targeted zone depending on your requirement.

3. Click the right mouse button to see the popup-menu. After setting the target zone, please click „Save setting”.

4. Enables / disables the motion detection function.

5. Set up the

sensitivity.

6. Click the

Submit button to submit the new setting of the recording.

7. Click the

Home button to return to the home page.

NOTE: Press and hold the „Ctrl” key on your keyboard and use the left mouse key to draw a blue rectangle

on the image to disable the motion detection area.

You also can click the left mouse key directly on a red check to disable it.

Description of function keys

The targeted zone: Click and drag the mouse across the targeted zone to draw a red rectangle on the image.

Detection Range: The red rectangle’s coordinates

Save: Click to save the motion detection range.

Motion Detection: This option enables / disables the motion detection function.

Sensitivity Level: Selects any one of the given options for the setup signal level or just type in the value of

Customized Threshold.

Submit: Click to submit the new setting to the Video Server.