Operating instructions

Digital Video Recorder
37
Highlight the box under the Alarm-Out heading and press the
button. A list of Alarm Outputs appears. You can
associate as many Alarm-Outs with that camera as you wish. When the DVR detects video blind on the selected camera,
it will trigger output signals on all the associated Alarm-Out connectors. You can also have the DVR’s internal buzzer
sound if video is blinded on the selected camera.
NOTE: For the Alarm-Out action, the alarm output and beep you select should be set to the Event mode in the
Alarm-Out setup screen (Schedule tab).
Highlight the box under the Notify heading and press the button. You can toggle the entire list On and Off by
highlighting Notification and pressing the
button. You can toggle the individual items On and Off by highlighting
that item and pressing the
button. Highlight OK and press the
button to accept your changes.
NOTE: For the Notify action, the notify item you select should be enabled in the Notification setup screen and
the DVR should be registered in the RAS (Remote Administration System).
Figure 52 — Video Blind Actions 2 screen.
Highlight the desired box under the PTZ heading, and press
the
button. A list of PTZ presets appears. Select the preset
position for each PTZ camera, where you want PTZ cameras
to move to when the DVR detects video blind on the selected
camera’s input.
Highlight the box under the Spot Monitor heading and press
the
button. A list of SPOT monitors and cameras appears.
Each SPOT monitor can be associated with a camera. The
DVR will display the associated camera on the SPOT monitor
whenever it detects video blind on the selected camera.
Text-In
Highlight Text-In in the Event menu and press the
button. The Text-In setup screen appears.
Figure 53 — Text-In Settings screen.
The DVR can be set to react to text input from devices such
as ATMs (Automated Teller Machines) and POS (Point of
Sale; i.e., cash registers). This screen allows you to configure
the DVR for each text-in device.
Highlight the box under the Setup heading, and press the
button. Selecting the Setup heading changes all the parameters
excluding Port settings of all the text input channels.
NOTE: The system performance might be affected when
a large quantity of text inputs are detected from
several channels at the same time.