Operating instructions

Operating Instructions

Highlight the LAN tab, and the LAN screen displays.

Figure 19 — LAN (Manual) setup screen.

Highlight the box beside Type and press the

button. You

can select the type of network configuration from: Manual,

DHCP and ADSL (with PPPoE). Select the desired type

and press the

button.

Selecting Manual from the Type allows you to set up LAN

parameters manually.

Change the numbers by highlighting them and using the Up

and Down arrow buttons to increase or decrease the number.

The factory default LAN settings are:

IP Address: 192.168.1.129

Gateway: 192.168.1.254

Subnet Mask: 255.255.255.0

NOTE: You will need to get the appropriate IP Address, Gateway and Subnet Mask from your network

administrator.

Highlight the box beside DNS Server. Press the Up and Down arrow buttons to set the IP address of the DNS server.

Highlight the Port Number Setup… box and press the button. The Port Number Setup screen appears.

NOTE: You will need to get the appropriate Port Numbers for each RAS and WebGuard related program (Admin,

Callback, Watch and Search) from your network administrator.

Change the numbers by highlighting them and using the Up and Down arrow

buttons to increase or decrease the number. The factory default Port settings are:

Remote Admin: 8200

Remote Callback: 8201

Remote Watch: 8016

Remote Search: 10019

NOTE: The system restarts automatically after changing the port settings.

Do NOT use the same port number for two different programs, otherwise, the DVR cannot be connected

with the PC running RAS or WebGuard.

CAUTION: When changing the port settings, you must change the port settings on the PC running

RAS or WebGuard as well. Refer to the RAS manual for details.

Selecting DHCP from the Type and highlighting Save button

reads the current IP address of the DVR configured by DHCP

(Dynamic Host Configuration Protocol) network.