Operating instructions

Digital Video Recorder

Shutdown

Highlight Shutdown in the System menu and press the

button. The Shutdown screen displays asking you to confirm

whether or not you want to shut the system down.

After selecting Shutdown and pressing the

button, a screen will appear telling

you when it is safe to disconnect power.

Figure 16 — Shutdown screen.

Network Setup

Figure 17 — Network menu.

Network

Highlight Network in the Network menu and press the

button. The Network setup screen displays. You will be

able to change the Network, LAN, DVRNS and WebGuard settings.

Highlight the first box beside Remote Watch – bps/ips.

Press the Up and Down arrow buttons to set the Transfer

Speed from 50Kbps to 100Mbps.

Highlight the second box beside Remote Watch – bps/ips.

You can select the unit of measure for the transfer speed

between: bps and ips. Press the

button to set the transfer

speed.

Highlight the box beside Remote Watch – Quality and press

the

button. You can select the Quality from: Very High,

High, Standard and Low. Press the

button to set the

Quality.

Figure 18 — Network setup screen.

Highlight the box beside Remote Watch – Resolution and press the

button. You can select the Resolution from:

High (Half D1) and Standard (CIF). Press the

button to set the Resolution.

NOTE: The higher Quality and Resolution settings require higher Transfer Speed settings. The transfer speed

you set is the maximum speed. Depending on the network environment, this speed may not be achieved.

You can limit the network bandwidth settings so that system does not consume too much network bandwidth. Highlight

the box beside Network Bandwidth Limit and press the Up and Down arrow buttons to set the desired maximum

bandwidth from 50Kbps to 100Mbps.

NOTE: When limiting the network bandwidth, the remote watch image on the PC running RAS or WebGuard

might not be displayed properly.