Operating instructions

Digital Video Recorder
3
Chapter 2 — Installation
Package Contents
The package contains the following:
y Digital Video Recorder
y Power Cord
y Operating Instructions (This Document)
y RAS Software CD and Operating Instructions
y Rack-mount Kit
y Assembly Screws and Guide Rails for Adding Hard Disk Drives
y Infrared Remote Control
Required Installation Tools
No special tools are required to install the DVR. Refer to the installation manuals for the other items that make up
part of your system.
Figure 2 — 16-Channel DVR rear panel.
Video Input Video Loop Through RS485 Port
Alarm Input/Output Network Port RS232C Port
Video Out Factory Reset Switch Power Cord Connector
Your DVR can be used with either NTSC or PAL equipment.
NOTE: You cannot mix NTSC and PAL equipment. For example you cannot use a PAL camera and an NTSC
monitor.
Video Input
Connect the coaxial cables from the video sources to the BNC Video In connectors.
Video Loop Through