Operating instructions

Operating Instructions

y To: Pressing the

button toggles between On and Off. When set to Off, you can enter a specific Date and Time.

When set to On, the search will be to the last recorded image.

y Check Time Overlap: Selecting the box and pressing the

button toggles between On and Off. You will be able

to turn the Check Time Overlap on or off only if user-defined date and time have been set in the From and To boxes.

If the DVR’s date and time have been reset, it is possible for the DVR to have overlapping start and stop times. When

set to On, you will be asked to select one of the overlapping start and stop times. When set to Off, the DVR will display

search results from all start times to all stop times.

y Alarm-In: Select the alarm inputs that you want to include in your search.

y Motion: Select the cameras for which you want any reports of motion detection.

y Video Loss: Select the cameras for which you want any reports of lost video.

y Text-In: Select the text-in devices which you want any report of text input.

y Record Channels: Select the cameras that you want to search for any reports of event recorded data. The DVR

will display the events (not the camera channels) that occurred and that also are recorded on the camera channel that

you selected. If you do not select a camera channel in this field, the DVR will search events that are not associated

with cameras.

y Check Recording, Check Alarm-In, Disk Almost Full, Disk Bad, Disk Temperature, Disk S.M.A.R.T., Fan

Error: Pressing the

button toggles between On and Off to include or exclude self-diagnostic events as part of

your search.

Once you set your desired search conditions, select Search and press the

button to display the search results in

the Event Log Search screen. Selecting Cancel exits the screen without saving the changes.

Record Table Search

Standard View

Compact View

Expanded View

Recording information about video images currently displayed on the screen displays in the recording status bar. A

grey vertical line indicates the current search position. To search for specific video, move the vertical line by pressing

the Left or Right arrow buttons on the remote control, scrolling the mouse wheel or clicking the mouse on the desired

segment.

If the DVR’s time and date have been reset to a time that is earlier than some recorded video, it is possible for the DVR

to have more than one video stream in the same time range. In this case, the overlapping time range in the record table

will be separated by a yellow vertical line.

NOTE: The recorded data in the time range located to the right of the yellow vertical line is the latest.

There are three view modes; Standard view, Expanded view and Compact view. Standard view (default) displays

combined recording information of all camera channels currently displayed on the screen. In the Standard view mode,

selecting the

icon located at the bottom switches to the Expanded view mode. The Expanded view displays the

recording information of each camera channel currently displayed on the screen. Selecting the

icon switches to the

Compact view mode which displays only the toolbar. Selecting the

icon in the Compact view mode switches to the

Standard view mode, and selecting the

icon in the Expanded view mode switches to the Standard view mode.