Operating instructions

Digital Video Recorder

NETWORK SETUP

General Settings (NETWORK ¼ General Tab)

y Remote Watch – bps/ips: Set the transfer speed, and select the unit of measure for the transfer speed between

bps (bit per second) and ips (image per second).

y Remote Watch – Quality: Select the quality of the transferred image.

NOTE: The local recording speed might be affected by various network bandwidth (Transfer Speed) conditions.

NOTE: The higher Quality settings require higher Transfer Speed settings. The transfer speed you set is the

maximum speed. Depending on the network environment, this speed may not be achieved.

y Network Bandwidth Limit: Set the desired maximum bandwidth. You can limit the network bandwidth settings

so that system does not consume too much network bandwidth.

NOTE: When limiting the network bandwidth, the remote watch image on the PC running RAS or WebGuard

might not be displayed properly.

y Enable WebGuard Service: Selecting the box turns the WebGuard service On. Select the port number used when

accessing WebGuard. See Appendix – WebGuard for details.

y Apply SSL to Transferring Data: Selecting the box turns the SSL (Secure Sockets Layer) authentication On. When

it is On, the security of data except video transmitted for remote monitoring or remote recording can be enhanced by

using the SSL authentication. When using the SSL function, the DVR cannot be connected with a remote program

or a network keyboard which does not support the SSL function.

CAUTION: The remote connection will be disconnected temporarily after changing the SSL

settings.

NOTE: This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit

(http://www.openssl.org/).