Operating instructions

33
2) MAIN Tab Window
To enable sequencing of camera the „EVENT POPUP” should be at „OFF” setting.
The „EVENT POPUP” will enable the event triggered camera to display on single channel view on the live view.
NOTE: In case events are (Motion or Alarm) simultaneously triggered on several channels then channel 1
has the first priority to pop up.
Example:
If events occur on channel 1, channel 2 and channel 4 at the same time then channel 1 has first priority.
Then channel 2 will be displayed with its dwell time setting.
However, even when motion is detected on channel 1 again within the dwell time of channel 2, pop up of channel 2
will stay in display.
If motion is still detected on channel 1 after dwell time, channel 1 pops up again before channel 4.
3) SPOT Tab Window
• SEQUENCE MODE: Define layout to sequence
between Full 1ch and 4ch split.
• SEQUENCE INTERVAL: Set sequence interval to 1,
2, 3, 4, 5, 10, 15, 20, 30 seconds.
• EVENT POPUP: Select „ON” or „OFF” to enable
popup screen for event trigger.
• POPUP EVENT TYPE: Select event trigger type
between motion detection and Alarm.
• POPUP DWELL: Set dwell time between 1, 2, 3, 4,
5, 10, 15, 20, 30 seconds.
• PIP: Set location of picture in picture window
(Upper part: 0~2, Middle part: 3~4,
Lower part: 5~7 )
• DURATION: Set dwell time for the PIP between 1,
2, 3, 4, 5, 10, 15, 20, 30 seconds
• SPOT MONITOR: Set Spot monitor „ON” or „OFF”.
• SPOT EVENT TYPE: Select Event type among
MOTION, ALARM and ALL.
• SPOT DWELL: Set dwell time between 1, 2, 3, 4, 5,
10, 15, 20, 30 seconds.
• SPOT CHANNEL: Invokes „SELECT SPOT
CHANNEL” popup menu.