System information

Enecsys Installation and Operation Manual – Version 1.6 –June 6 2012
7
1.5 Installation compliance requirements
• The Installation must be wired in accordance with the regulations in force in the
country where the micro inverters are to be deployed. For example:
For the UK: IEE Wiring Regulations, BS 7671, latest edition
ATTENTION: Protection on the AC wiring
Further protection on the AC wiring from the inverters must be provided and
may be required by local and national wiring Regulations. This protection is
likely to include Residual Current Devices, Earth Fault Monitors and/or
Circuit Breakers.
This product can cause current with a DC component. Where a residual
current-operated protective (RCD) or monitoring (RCM) device is used for
protection in case of direct or indirect contact, only an RCD or RCM of Type
B is allowed on the supply side of this product.
ATTENTION: Voltage drop across the AC wiring
To ensure that the system is operating efficiently, the voltage drop across
the AC wiring should be measured. This is best done by direct measurement,
but can be arrived at by calculations, graphs or tables.
ATTENTION: Installation Testing: Initial verification
Before being connected to the grid mains supply, the wiring installation must
be inspected and tested to verify that the requirements of the regulations
have been met. The type and level of the tests must be in accordance with
the local and national regulations. Suitably qualified persons must carry out
the tests and the interpretation of the results.
ATTENTION
The inverter handle is not designed to support weight in excess of thirty
pounds (13.6kg) of static pressure. Do not stand on, or place excessive
weight on, Enecsys inverters.
ATTENTION
The gateway and repeater/double repeater are intended for stationary indoor
use only.
- Do not mount in a location where they will be exposed to
direct/excessive solar and/or heat radiation.
- Do not expose to heat-trap conditions or to water condensation.
- Do not use liquid or aerosol cleaners when cleaning: clean only with a
damp cloth.
- Do not use near water.
- Transition of these items between temperature extremes may cause
condensation on some of the internal parts. If you notice
condensation on or behind the product’s display window, allow it to
dry naturally before re-connecting to the main electrical supply.