System information

Enecsys Installation and Operation Manual – Version 1.6 –June 6 2012
6
WARNING
Isolation of the AC cabling
The AC wiring from the inverters must have provision for electrical
isolation from the grid mains supply (for example, by using a circuit
breaker), so that inspection, fault detection, testing, maintenance and
repair can be performed.
WARNING
Never disconnect any Photovoltaic module from an Enecsys micro
inverter without first isolating the AC mains.
WARNING
The inverter and metalwork must be earthed/grounded in accordance
with national and local electrical standards.
WARNING
Enecsys micro inverters, gateways and repeaters contain no user-
serviceable parts. Do not attempt to open or repair. Opening or tampering
with the Enecsys micro inverter, gateway or repeater will void the warranty.
• If your micro inverter(s) fail(s), contact your installer company or the
Enecsys help desk.
• New units with damage must not be installed: return them to the
supplier.
WARNING
If either the gateway or the repeater/double repeater exhibit any of the
following characteristics unplug the products from the mains electrical
supply. Contact either your distributor or installation company.
- The power supply or its plug is damaged.
- If liquid has been spilled into the product.
- The product has been exposed to rain or water.
- If the product does not operate properly.
- If the product has been dropped or damaged in any way.
- If there are noticeable signs of overheating
CAUTION
The Aluminum body of the Enecsys micro inverter serves as the heat sink for
the unit and as such can reach temperatures of 70
o
C. The Enecsys micro
inverter should not be touched while in operation.