System information

Enecsys Installation and Operation Manual – Version 1.6 –June 6 2012

6 Installing the micro inverters

• Note that a Torx t20 driver is required for the inverter ground/earth connections.

• Use the “PV module / micro inverter serial number grid” sheet in section 10 to keep

track of the inverter serial numbers as they are installed in place. The stickers on the

inverter packaging should be removed and stuck to the sheet to refer to later. The

sheet will be used during the Installation Finalization step: see section 7 for details.

6.1 Single micro inverter

A Enecsys single micro inverter

B Distribution unit (connection block)

C PV module

D Grid connect cable

E Enecsys repeater

F Enecsys gateway

G Enecsys monitoring

H Country specific disconnect (such as an isolation switch)

I Generation meter

J Mains AC utility

Each single micro inverter connects to one photovoltaic module.