System information
Enecsys Installation and Operation Manual – Version 1.6 –June 6 2012
22
5.4.1 Mounting the single repeater
• The single repeater must be installed indoors near a mains power socket.
• It can be freestanding, either upright as shown in the illustration, or laid flat on its
plastic feet.
• It can be wall mounted using two screws in the position shown in the diagram.
• It can be mounted using sticky pads in the position shown in the diagram.
• It can be attached to a roof truss or a pillar or a pipe using a cable tie passed
through the cutouts shown in the diagram.
5.4.2 Connecting the single repeater
Connection: the single repeater requires 5V DC power input from the plug-top power supply.
• Pass the DC power cable through the slot in the lower side of the case as shown in the
diagram.
• When the DC power adapter is switched on at the mains, the single repeater will start
working immediately.
• Observe the communication connection quality on the Enecsys gateway Installer Mode
screen – it should now display the check ! symbol.