System information

Enecsys Installation and Operation Manual – Version 1.6 –June 6 2012
15
3.2 Connecting the gateway
• The Enecsys gateway requires the following connections:
o 5V DC power input from the plug-top power supply.
o Ethernet connection to the customer’s router.
• When the DC power adapter is switched on at the mains, the Enecsys gateway will
power up immediately and its screen will display the “User Mode” screen. To enter
installation information, the gateway needs to be in Installer Mode. After the
installation is complete, switch back into User Mode.
3.2.1 Switching User and Installer modes
Connect one end of the supplied
Ethernet cable to a spare Ethernet port
on the rear of the customer’s router.
Connect the other end of the supplied
Ethernet cable to the Ethernet port on
the left hand side of the Enecsys
gateway.
Connect the supplied 5V DC plug-top
power adapter jack to the 5V DC-in
power socket on the left hand side of
the Enecsys gateway.
Connect the 5V DC plug-top power
adapter to a mains power source. The
gateway will power up immediately in
User Mode.
To access the Installer Mode screen:
insert the sharp end of a pencil or a
straightened paper clip into the Installer
Mode recess on the left hand side of
the Enecsys gateway for approximately
5 seconds.
To return to the User Mode screen:
press on the Installer Mode button for a
short period.
Once installed, do not disconnect or
move a gateway. This may interfere
with the transmission of data resulting
in incorrect values being displayed on
the monitoring site.