Specifications

Double Repeater
10 of 20 Installation
Wall mounting the double repeater (adhesive pad method)
1. Ensure that the back-plate of the double-repeater, wall or mounting
surface is clean from dust and grease.
2. Attach the antenna to the lower SMA connector on the right hand
side of the double-repeater, simply screw the antenna into place in a
clockwise direction.
3. Connect the 5V supplied PSU to an AC power source, wall socket.
4. Connect the DC power jack to the DC power port on the reverse of
the repeater thread the cable through the power supply cable conduit
on the back-plate of the double-repeater, this will help to keep the
cable in place and prevent the power source from becoming detached.
5. Remove the backing material from one of the double sided adhesive
pads and place firmly onto the fixing points on the back of the double-
repeater. Repeat the process for the remaining two double sided
adhesive pads.
6. Remove the remaining backing material from the adhesive pads
attached to the back-plate of the double repeater, press the double-
repeater firmly into place on the wall/mounting surface.