Installation guide

Installation manual Intelligent Reliable Power

Notes:

• Once the Photovoltaic modules are exposed to daylight and connected to the Enecsys Micro-

inverters, the inverters will start communicating with the Gateway.

• Energy production will only commence once the AC cabling is connected to the AC utility grid.

• Each Micro-inverter has two DC link cables, one male and one female. The DC harness link

cables are terminated with single pole connectors of various types, depending on the installa-

tion and have a nominal length of 150 mm.

The connectors used on all Enecsys Micro-inverters are compliant with all major PV module

manufacturers DC link connectors. These connection types are as follows:

•Multi-Contact MC3.

•Multi-Contact MC4.

• Huber & Suhner Radox.

•Tyco Solarlok System.

Connect the DC cable link harness from the Micro-inverters to the DC cabling from PV module's

junction box.

Depending on the type of connector present ensure that all snap closures are secure and that

push connectors are twist locked.

This is a note, it

brings to your

attention some

thing which you