Installation guide

Installation manual Intelligent Reliable Power

5. Mounting Enecsys Micro-inverters

Attention: Ensure that there is a gap of at least one cm. (10mm) between the Micro-inverter and

the back of the PV module.

Attention: Ensure that there is a gap of at least one cm. (10mm) between the Micro-inverter and

the roof surface.

Attention: Ensure that there is sufficient space to mount the Micro-inverter. see Figure 3 for

inverter dimensions.

FIGURE 2. Micro-inverter placement showing a 10mm gap between the mounting surface and PV module.

Lay-out all of the Enecsys Micro-inverters next to their corresponding positions as indicated by

the installation map, matching the serial numbers on the inverters with those shown on the map.

Depending on the PV mounting type used, mount the Micro-inverters using the most appropriate

mounting method.

10 mm min