System information

8 Installation and Operation Guide Enecsys LLC • 275 Redwood Shores Drive • Redwood Shores, CA 94065 • www.enecsys.com
2.5. Connect the AC Cabling to the AC Module
See “6.2. Installing and connecting the AC bus cabling” on page 24.
2.6. Confirm communications between micro inverters and Gateway
By looking at the screen on the Gateway unit, the installer can see if the Gateway is receiv-
ing a good signal from all of the micro inverters. See “4.1. Enecsys Gateway Setup” on page
12.
If communications have not been established, it may be necessary to install one or more re-
peaters. See ”Chapter 5 Using Enecsys Repeaters” on page 21.
2.7. Set up the new installation on the Monitoring website
• If the installer has not worked with Enecsys micro inverters before, it’s time to set up an
Installer Account. For setup details, see section “7.1. Installer login for Enecsys Monitoring
System” on page 30.
• Before installing the gateway, the installer should log onto the Monitoring website with the
installer account and set up the individual installation. The installer will need details such as
the homeowner’s name and email address, street address of site, estimated yearly energy
production, and average cost of electricity per kilowatt-hour.
2.8. Finalize installation and user details; launch the installation
• See “7.3. Installation and launch” on page 35.