System information

NNN-NNN r001 Enecsys Installation and Operation Guide 5
1.3. Conventions used in this manual
The following conventions are used throughout this manual. These conventions should be
noted and followed at all times.
!
!
1.4. Safety
Original equipment manufacturers must provide adequate safety warnings relevant to their
product.
Before installing and using equipment with integrated Enecsys micro inverters, please ensure
that you have fully read and understand all of the installation instructions and heed all warn-
ings and cautions given.
The following warnings apply
to Enecsys components:
!
WARNING
Warning statements must be heeded at all times. A warning symbol in-
dicates that a process or instrument has the potential to harm or cause
lethal injury if the correct method of handling is not employed.
CAUTION
Caution Statements are used to indicate where a part of a process may
have the potential to damage equipment. Caution statements should be fol-
lowed at all times.
ATTENTION:
Attention statements are used to indicate where a part of the process has a
special requirement. Attention statements should be followed at all times.
WARNING
AC Cable harness must be connected to the mains utility grid by a
electrician.
CAUTION
Enecsys micro inverters, gateways and repeaters contain no user-service-
able parts. Do not attempt to open or repair. Opening or tampering with the
Enecsys micro inverter, gateway or repeater will void the warranty.
• If a component fails, contact the supplier.
• New modules that have micro inverters that appear to be damaged should
not be installed: contact the supplier.