System information

28 Installation and Operation Guide Enecsys LLC • 275 Redwood Shores Drive • Redwood Shores, CA 94065 • www.enecsys.com

a) Strip cable jacket

18-25 mm

b) Separate the seal/clamp ring and sealing nut,

then insert the stripped cable end through

them in the order shown.

c) Insert the wire ends

into the receptacles.

d) Push the cable to the end.

Gently test the cable to see if

it is secured.

e) Screw the sealing nut into the body.

Recommended torque = 25Kgf-cm

Body

Seal/clamp ring

Sealing nut

Figure 23. T-cable end cap installation

T-Cabling System: connections to the AC branch system

Connect the unterminated end of the

T-cable to the AC Mains.

WARNING

Connection of the AC cable to the mains

electrician.

ATTENTION:

Disconnecting a drop cable connection from the inverter AC connector requires the Mi-

cro Inverter AC disconnect tool. It is the same tool that is used to remove the protective

caps from the drop cable connectors.

6.3.2. Cable Joiner

• The cable joiner can be used to connect sections of trunk cabling.

• When used as directed, the cable join will be able to withstand outdoor conditions.

• Once the housing is joined, separating the halves requires its own disconnection tool.

ATTENTION

Make sure each

individual conductor

into one receptacle.