System information

NNN-NNN r001 Enecsys Installation and Operation Guide 23

C The communication check symbol.

Figure 20. Enecsys Gateway Default View

If the correct number of inverters and repeater are not showing, consult the troubleshooting

section of the Gateway Installation “Table 2. Status bar troubleshooting” on page 15.

• Plug the power adapter into the outlet/mains. When the DC power adapter receives power

from the outlet/mains, the single repeater should start working immediately.

ATTENTION

After the installation is complete, the gateway should be returned to the default

view and left that way during customary operation.