System information

22 Installation and Operation Guide Enecsys LLC • 275 Redwood Shores Drive • Redwood Shores, CA 94065 • www.enecsys.com
5.4. Mounting the single repeater
• The single repeater must be installed indoors near an outlet/mains power socket.
• It can be freestanding, either upright as shown in the illustration, or laid
• It can be wall mounted using two screws in the position shown in the diagram.
• It can be mounted using sticky pads in the position shown in the diagram.
ADHESIVE FIXING POINTS
SCREW FIXING POINTS
50 mm
CABLE TIE
FIXING POINT
Figure 18.
5.4.1. Connecting the single repeater
Figure 19. 5V power input to repeater
The single repeater requires 5V DC power input from the plug-top power supply.
• Pass the DC power cable through the slot in the lower side of the case as shown in “Figure
19. 5V power input to repeater”.
• When the DC power adapter receives power from the outlet/mains, the single repeater will
start working immediately.
• Go through the initial steps of the Gateway Installation Wizard: see “4.1. Enecsys Gateway
Setup” on page 12.
• Observe the communication connection quality on the Enecsys gateway default view screen.
It should now display:
A The correct number of inverters.
B The repeater.