System information

NNN-NNN r001 Enecsys Installation and Operation Guide 11
3.2.1. Connecting the Gateway to an Ethernet router
Connect one end of the supplied Ethernet cable to
a spare Ethernet port on the rear of the customer’s
router.
ROUTER
ETHERNET CABLE
Connect the other end of the supplied Ethernet cable
to the Ethernet port on the left hand side of the Enec-
sys gateway.
Connect the supplied 5V DC plug-top power adapter
jack to the 5V DC-in power socket on the left hand
side of the Enecsys gateway.
Connect the 5V DC plug-top power adapter to a
mains power source. The gateway will power up im-
mediately.
5V DC
ETHERNET
CABLE
Once installed and when all the system components
are showing correctly, do not disconnect or move a
gateway. This may interfere with the transmission of
data resulting in incorrect values being displayed.
Figure 4. Gateway initial display screen