Instructions / Assembly

9Version 1.9
English
6) Mount the 30’ arm extension to the
existing 20’ boom wing end.
5) Flip the boom arm up to a 90° angle
and tighten each side of the boom
until the spring is compressed. This will
ensure there is enough pressure on
the spring to hold the boom in fold out
position.
8) Take the hose extension and screw
it to the existing brass fitting on the 20’
wing. Follow the same procedure for
the boom on the other side. Your 30’
extension is now plumbed to the 20’
boom.
7) Insert the bolt through the top hole
of both the 20’ and 30’ wing ends and
tighten securely. This will allow the 30’
wing extension to fold up over the 20’
wing.
INSTALLING THE 30’ EXTENSIONS
20/30’ STEEL BOOM
Assembling 20/30’ Steel Boom
GETTING STARTED