Instructions / Assembly

4 Steel Boom | Boomless Nozzle Kit
English
1) To install boom brackets to the spray-
er, insert the 3/8” x 1” bolts through the
bracket and place plastic washers over
bolts to hold them in place. The plastic
washer will hold the bolt in place when
connecting slide brackets to the C-brack-
et in step 2.
2) Connect the brackets by sliding the
3/8” x 1” bolts through the C-bracket on
unit and install 3/8” washer and 3/8” lock
nuts loosely. Leaving these bolts loose
allows the bracket to adjust in step 3.
3) To install your boom to the brackets,
loosen the carriage bolts on the boom
(leaving nuts and washers on bolts).
Align carriage bolts with quick attach
brackets and slide them into the brack-
et slots, then lower the boom down to
desired height.
4) When the boom is set to desired
height, tighten the hardware listed in
steps 2 & 3, making sure the square
neck on the carriage bolt is fully inserted
through the slot.
Mounting Your Boom
GETTING STARTED