Product Manual

Model RWP2000-01 and RWP2000-02
10. DO NOT APPLY A LOAD to the winch
when the winch cable is fully extended.
The cable anchor on the winch is not
capable of holding the maximum rated
load capacity.
11. STAND BACK
Stay out of the direct line that the
winch cable slips or breaks, it will
“whip lash” along this line.
winch cable is pulling. In the event the
FITTING THE CABLE:
FITTING THE CABLE for RWP2000-01:
Push the steel cable into Drum cable
hole. Let the cable extrude out of the
hole by 15mm (not exceeding drum
circumference). Screw the cable
tightly.(Figure 7)
Assembly
1. Loosen the thumbscrew and slide the
handle toward the Adjustable handle
holder as shown
(see Figure 4)
2. Line up the notch in the handle with the
point of the Hex in the Holder.
3. Slide the handle and Holder install
onto the Hex drive on the brake until
the flat of the handle lines up with the
groove in the Hex drive. (see Figure 5-1,
5-2)
thumbscrew
notchnotch
slide
Adjustable
handle holder
Figure 4
Figure 3
Figure 5-1
groove
Figure 5-2
Figure 6
slide handle out to desired length
and tighten thumbscrew
Handle Installing for RWP2000-01
4. Slide the handle outward away from
the Holder to the desired length then
tighten the thumbscrew. (see Figure 6)
Handle Installing for RWP2000-02
1. Insert Handle Assembly into the
handle Socket. Adjust the handle
length to suit the operation.
2. Tighten the set screw to hold it in
place.
3. Insert Cotter Pin into the pin hole
at the end of the handle and bend
it to secure in place.
FITTING THE CABLE for RWP2000-02:
Put the ball-headed steel cable into
Drum cable slot. Let the cable extrude
out of the slot by 20mm (not exceeding
drum circumference).
Screw the cable tightly.(Figure 8 )
Drum
Screw
Steel Cable
Figure 7
Figure 8
handle flat lines up
with groove
3