Product Manual

- 05 -
Figure 23
Figure 20
Figure 19
Figure 21
Figure 22
7) Install the handle on the lower end of the boom, applying
the clevis pin and lynch pin provided. The lynch pin is fixed
with the carrying handle by the wire rope. See Figure 19.
8) Secure the hand winch to the mounting plate (Figure 20)
using hardware.
9) Install the handle onto the hand winch and tighten the
fastening screw. See Figure 21.
10) Installing the wire rope:
ÊÊÊÊUÊ*ass the wire rope over the sheave at the end of the boom.
See Figure 22.
UÊÊÃiÀÌÊÊÌiÊÃÌiiÊV>LiÊÌÀÕ}ÊÌiÊõÕ>ÀiÊÊiÊÊvÀÊÊÃ`iÊÊ
to outside.
Thrust the steel cable into one side of the cable anchor .
Insert the cable end into the other side of the cable anchor
leaving a large loop outside.
/}ÌiÊÊÌiÊÊÕÌÊÊÃ}ÌÞ°Ê*ÕÊ>`ÊÀi`ÕViÊÊÌiÊ«Ê`ÜÊÌ
the cable anchor . (See Figure.23)
Figure 18
6) At the very front sides of the boom, install the stop pin and
put the hair cotter pin into the stop pin to secure it in place.
See Figure 18.