Product manual

KP915GV Product Manual
96
4.11 Tamper Detection
When detecting the tamper signal low, BIOS can be configured to display a warning message or to
require a password at the next boot. Since the lithium cell powers the logic, the tamper detection
continues to operate even if the board is un-powered.
4.12 OEM Features
Note: Always refer to the applicable “read me” file available in the BIOS Configuration Tools
section of the 915 boards Technical Support Library under the Products section of the
RadiSys web page “www.radisys.com.”
4.12.1 POST Logo Change
CBROM.exe is the Award BIOS ROM combination utility. CBROM runs at a DOS prompt. Use the
following command to change a full-screen logo to your BIOS bin file.
Cbrom AAA.bin /logo test.bmp
NOTE
The full-screen logo file must be 640X464 pixels with 16 colors BMP format.
4.12.2 CMOS Default Change
The MODBIN6.EXE is the utility that runs at a DOS prompt for binary code manipulation. It allows
selection of customized default CMOS (BIOS setup) settings. The process is described below:
Execute the MODBIN6.exe
•
Load the BIOS bin file by the ‘File’ option.
• Change the ‘Edit Setup Screen’ to change the default settings.
• Save the modified BIOS file by ‘File’ option.