Product manual

KP915GV Product Manual
11
Product Specification Overview
Item Description
Network
Intel 82573V (or ‘L) PCI-E Gbit Ethernet controller, co-lay with Intel 82562GZ
10/100 PHY (using the integrated MAC)
Available with second Intel 82573V (or ‘L) Gbit Ethernet controller
Disks
Four SATA ports with locking headers
Single Ultra ATA/100 interface supporting hard disks and ATAPI drives
One FDD interface
Super I/O &
H/W Monitor
Winbond PC8374 Super I/O and Nat Semiconductor LM9600 hardware
monitoring device
Automatic fan speed control based on thermal monitoring (note that the BIOS
Setup is used for configuration and status information)
Header
Connectors
GPIO 2 x 10 pin with housing
SMbus 1 x 4 pin with housing
COM2 2 x 5 pin with housing
Kbd/Mouse 1 x 4 pin with housing
Remote thermal sensor 1 x 2 pin with housing
FDD 1 x FDD connector
1394b 2 x 5 pin connector
I/O Panel
PS/2 keyboard and mouse
Analog VGA
Bi-directional/EPP/ECP parallel port
COM1 RS232
One or two dual USB + RJ45 stacks
Audio jack stack (2 jacks)
RadiSys PLD
Lattice LC4128ZC-75TN100C PLD for watchdog, GPIO, BIOS write-protect
support
1.1 Accessories
There are two I/O shields, one for a single Ethernet configuration and one for a dual Ethernet
configuration, and an available fan heat sink for the processor. These are separately orderable
product codes. There are currently no dual Ethernet versions of the KP915GV board. Note that
the order codes directly below do not comply with RoHS regulations.
ATX-L KP IOSHLD ATX I/O Shield for Single Ethernet
ATX-2L BLK IOSHLD ATX I/O Shield for Dual Ethernet
FNSNK P4-775
Fan Sink for LGA775 Pentium 4 Processors
RoHS regulation-compliant product code versions of these items are as follows.
ATX-2L BLK IOSHLDR IO Shield - Dual Ethernet ROHS
ATX-L KP IOSHLDR
IO Shield – Single Ethernet ROHS
FNSNK P4-775 R Fan Sink - LGA775 P4, ATX ROHS