User's Manual

Micropilot NMR84
Endress+Hauser 33
Ordering information
Ordering information
Detailed ordering information is available from the following sources:
•
In the Product Configurator on the Endress+Hauser website: www.endress.com -> Click "Corporate"
-> Select your country -> Click "Products" -> Select the product using the filters and search field ->
Open product page -> The "Configure" button to the right of the product image opens the Product
Configurator.
• From your Endress+Hauser Sales Center: www.addresses.endress.com
Product Configurator - the tool for individual product configuration
•
Up-to-the-minute configuration data
• Depending on the device: Direct input of measuring point-specific information such as
measuring range or operating language
• Automatic verification of exclusion criteria
• Automatic creation of the order code and its breakdown in PDF or Excel output format
• Ability to order directly in the Endress+Hauser Online Shop
Calibration certificate
Option of ordering
feature 150 "Accuracy,
Weight + Measure
Approval"
1)
Calibration certificate Position of the calibration points
2)
ICW 3-point • 2 m (6.6 ft)
•
15 m (49 ft)
• 30 m (98 ft)
ICX 5-point • 2 m (6.6 ft)
• 9 m (30 ft)
• 15 m (49 ft)
• 21 m (69 ft)
• 30 m (98 ft)
• NTA (in preparation)
•
NTC (in preparation)
• PTA (in preparation)
• PTC (in preparation)
10-point • 2 m (6.6 ft)
• 6 m (20 ft)
• 9 m (30 ft)
• 12 m (39 ft)
• 15 m (49 ft)
• 18 m (59 ft)
• 21 m (69 ft)
• 24 m (79 ft)
• 27 m (89 ft)
• 30 m (98 ft)
1) Positions 21 to 23 of the order code
2)
Distance measured from the lower edge of the mounting flange
The position of the calibration points may vary by ±1 cm (±0.04 in).
The calibration points are checked under reference conditions.