Operating Instructions
Table Of Contents
- Table of contents
- 1 About this document
- 2 Basic safety instructions
- 3 Incoming acceptance and product identification
- 4 Installation
- 5 Electrical connection
- 6 Operation options
- 7 System integration
- 8 Commissioning
- 9 Diagnostics and troubleshooting
- 10 Maintenance
- 11 Repair
- 12 Accessories
- 13 Technical data
- 14 Operating menu and parameter description
iTEMP TMT72 Operating menu and parameter description
Endress+Hauser 73
Navigation Application → Measured values → SV
Description Displays the secondary device variables.
TV
Navigation Application → Measured values → TV
Description Displays the tertiary device variables.
QV
Navigation Application → Measured values → QV
Description Displays the quartenary (fourth) device variables.
14.2.2 Submenu: Sensor
Unit
Navigation Application → Sensor → Unit
Description Use this function to select the engineering unit for all the measured values.
Options • °C
• °F
• K
• Ω
• mV
Factory setting °C
Additional information Please note: if another unit has been selected instead of the factory setting (°C), all
the set temperature values are converted to correspond to the configured
temperature unit.
Example: 150 °C is set as the upper range value. Following the selection of °F as the
engineering unit, the new (converted) upper range value = 302 °F.
Sensor type
Navigation Application → Sensor → Sensor type