Operating Instructions

iTEMP TMT72 Operating menu and parameter description
Endress+Hauser 61
14 Operating menu and parameter description
The following tables list all the parameters in the "Guidance, Diagnostics, Application
and System" operating menus. The page number refers to where a description of the
parameter can be found.
Depending on the parameter configuration, not all submenus and parameters are
available in every device. Information on this can be found in the parameter
description under "Prerequisite".
This symbol indicates how to navigate to the parameter using operating tools (e.g.
FieldCare).
Guidance → Commissioning →

Commissioning wizard
Start
→  32
Guidance → Create documentation
1)
Save / Restore
1)
Compare
1)
1) These parameters only appear in FDT/DTM-based operating tools, such as Endress+Hauser's FieldCare and DeviceCare
Diagnostics → Actual diagnostics → Actual diagnostics 1 →  65
Operating time →  65
Diagnostics → Diagnostic list → Actual diagnostics 1, 2, 3 →  65
Actual diag channel 1, 2, 3 →  65
Time stamp 1, 2, 3 →  66
Diagnostics → Event logbook → Previous diagnostics n →  66
Previous diag n channel →  66
Time stamp n →  67
Diagnostics → Simulation → Diagnostic event simulation →  67
Current output simulation →  67
Value current output →  67
Sensor simulation →  68
Sensor simulation value →  68
Diagnostics → Diagnostic settings → Properties → Alarm delay →  68
Sensor line resistance →  69
Limit corrosion detection →  69
Thermocouple diagnostic →  69
Diagnostic behavior→
Sensor, electronics, process, configuration
→  69
Status signal →
Sensor, electronics, process, configuration
→  70