Operating Instructions
Table Of Contents
- Table of contents
- 1 About this document
- 2 Basic safety instructions
- 3 Incoming acceptance and product identification
- 4 Installation
- 5 Electrical connection
- 6 Operation options
- 7 System integration
- 8 Commissioning
- 9 Diagnostics and troubleshooting
- 10 Maintenance
- 11 Repair
- 12 Accessories
- 13 Technical data
- 14 Operating menu and parameter description
iTEMP TMT72 Commissioning
Endress+Hauser 33
In the third section, the settings are made for the analog output and the output's alarm
response. The following parameters can be configured:
Navigation Guidance → Commissioning → Current output
+
+
-
A0037390-EN
4 mA value
20 mA value
Failure mode
Failure current
In the final section, a password can be defined for the "Maintenance" user role. This is
strongly recommended to protect the device against unauthorized access. The following
steps describe how to configure a password for the "Maintenance" role for the first time.
Navigation Guidance → Commissioning → User management
+
+
-
A0037391-EN
Access status
New password
Confirm new password
1. The Maintenance role appears in the "Access status" picklist. The Maintenance user
role must first be selected when operating with the SmartBlue App.
Afterwards, the New password and Confirm new password input boxes appear.
2. Enter a user-defined password that meets the password rules indicated in the online
help.
3. Enter the password again in the Confirm new password input box.
Once the password has been entered successfully, parameter changes, particularly those
that are needed for commissioning, process adaptation/optimization and troubleshooting,
can only be implemented in the Maintenance user role and if the password is entered
successfully.
8.4 Protecting settings from unauthorized access
8.4.1 Hardware locking
The device can be protected against unauthorized access by hardware locking. In the
locking and access concept, hardware locking always has top priority. The device is write-
protected if the keyhole symbol appears in the header of the measured value display. To
disable write protection, switch the write protection switch on the back of the display to
the "OFF" position (hardware write protection). → 19
8.4.2 Software locking
By assigning a password for the Maintenance user role, it is possible to restrict access
authorization and protect the device against unauthorized access. See the Commissioning
wizard → 32
Commissioning wizard → 32