Operating Instructions
Table Of Contents
- Table of contents
- 1 About this document
- 2 Basic safety instructions
- 3 Product description
- 4 Incoming acceptance and product identification
- 5 Installation
- 6 Electrical connection
- 7 Operation options
- 8 Commissioning
- 9 Operation
- 10 Diagnostics and troubleshooting
- 11 Maintenance
- 12 Repair
- 13 Accessories
- 14 Technical data
- Index
Micropilot FWR30 Basic safety instructions
Endress+Hauser 7
‣
Observe federal/national regulations pertaining to the repair of an electrical device.
‣
Use original spare parts and accessories from Endress+Hauser only.
Hazardous area
To avoid danger to individuals or the facility when the device is used in the approval-
related area (e. g. explosion protection, pressure vessel safety):
‣
Check the nameplate to verify if the device ordered can be put to its intended use in the
approval-related area.
‣
Observe the specifications in the separate supplementary documentation that is an
integral part of these Instructions.
2.4.1 Safety notice for the device battery
L
CAUTION
Risk of fire or burns if the device battery is handled incorrectly!
‣
Do not charge or open the battery, expose it to fire or heat it above 100 °C (212 °F).
‣
Only replace the battery with a ER34615 battery (lithium-thionyl chloride primary
battery, size D). The use of any other battery can present a fire or explosion hazard.
‣
Dispose of the used battery immediately as per national regulations.
‣
Keep used batteries out of the reach of children. Do not open used batteries or expose
them to fire.
2.5 Product safety
This measuring device is designed in accordance with good engineering practice to meet
state-of-the-art safety requirements, has been tested, and left the factory in a condition in
which it is safe to operate.
It meets general safety standards and legal requirements. It also complies with the EC
directives listed in the device-specific EC Declaration of Conformity. Endress+Hauser
confirms this by affixing the CE mark to the device.
2.6 IT security
We only provide a warranty if the device is installed and used as described in the
Operating Instructions. The device is equipped with security mechanisms to protect it
against any inadvertent changes to the device settings.
IT security measures in line with operators' security standards and designed to provide
additional protection for the device and device data transfer must be implemented by the
operators themselves.