Installation Manual

Remove two (2) M8 hex cap screws from the left rear frame rail.
(If AltRider skid plate bracket is alread installed, leave it in place).
10
(A) Tighten the M10 hex cap frame screws to 49Nm.
(B) Tighten the M10 socket cap screws to 40Nm.
(C) Tighten M8 socket cap screws to 23Nm.
9
Honda Africa Twin // Low Crash Bars // Installation Instructions
Install Left bar. Add a drop of thread locker to each screw before installation.
(A) Use two M8 x 25 socket cap screws at the front (supplied with Bracket Set kit).
(B) Use two M8 x 25 hex cap screws at the rear (supplied with Crash Bar kit).
Tighten all M8 screws to 23Nm.
4
Attach right side crash bar. Place a drop of thread locker onto each screw.
(A) Use two M10 x 25 socket cap screws with washers at the rear (supplied with Crash Bar kit)
(B) Use one M8x25 socket cap screw with washer in upper location.
(C) If installing Low Bars only, use M8 x 16 socket cap screw with washer. If installing Lower
and Upper bars, you will use the longer M8 x 25mm socket cap screw here. (do not tighten
until upper bar ange in place).
11
12
A
B
A
B
C
A
B
C