Installation Manual

Install the Right Rear bracket.
If you are installing the AltRider Skid Plate, pause and install the skid plate
rear mounting bracket now (it also uses these mounting bolts).
Use a drop of thread locker on each screw.
(A) Use the included AltRider M10 x 85mm screw in the rear position.
(B) Use the OEM Honda M10 x 75mm screw in the forward position.
Thread on the M10 nuts, but leave loose for now.
6
Remove both screws. discard the forward, shorter (60mm) screw, but
keep the nut. !!TIP If removing the screws is dicult, wrap a screwdriver
or small pry bar with cloth and lever the frame rail downward to release
the pressure on the screw.
5
Honda Africa Twin // Low Crash Bars // Installation Instructions
8
Inspect headers for blow by (not likely) and replace gaskets if worn. Reinstall
exhaust, (steps 1 -5 in reverse order. ) Don’t forget to clip the o2 sensor wire in
place. TECH TIP: The gaskets can be annealed by removing each and heating
to cherry red to anneal and allow re-use.
7
3
Use 14mm spanners to loosen both frame rail M10 screws and nuts.
A
B