Installation Manual

2
Use 6mm allen tool and remove the screw that holds the exhaust canister.
Prepare a loop of safety wire or zip ties, or some other method of hanging
the exhaust from this mounting point. (A) A section of safety wire can be
twisted as shown and used to take up any slack.
2
Use 12mm socket with extension, loosen the four (4) acorn nuts that hold
the exhaust header anges. Do not remove completely, but make very
loose.
1
Honda Africa Twin // Low Crash Bars // Installation Instructions
4
Use 12mm spanner and socket and remove the lower exhaust hang-
ing bolt. The entire loosened system will now hang slightly lower.
3
Depress locking tabs and unfasten the small clip that holds the oxygen sensor
wire to the ll reservoir (located near the rear brake pedal).
Install the Bracket Set AT16-9-1000 before installing
either the lower or upper crash bars.
A