Specifications

Coping

COPING:

The top edge of the Fiberglass Endless Pool is typically covered with a cantilevered coping/decking system as shown on

one of the drawings below. These sketches are not intended as construction drawings and many other solutions appro-

priate for a wet pool environment may be employed. Please note that the coping at the front of the pool may not

overhang the water since the skimmer/filter faceplate slides up during filter changes. Before setting coping remove this

faceplate to better understand this constraint.

FULLY IN-GROUND WITH POURED CONCRETE DECK

With this system, after backfilling the pool, a concrete deck is poured that comes right up to the water’s edge. Special forms are

available that can provide are adhered to the wall of the pool creating the bullnose and are removed before the concrete has cured.

FULLY IN-GROUND WITH A STONE OR TILE SURROUND

Pouring a concrete deck around the pool flush with the top edge of the fiberglass allows for a stone

surface to be laid up to the water’s edge.