Specifications

ManualsBrandsEndless Pools ManualsHome building and DecorPools

Equipment

LOCATION OF EQUIPMENT

The equipment to filter and heat your Fiberglass Endless Pool

is typically installed at the front of the pool just below the

fiberglass lip (see figure below). The keypad controller for this

system has a 10 foot cord and is usually mounted in the pool

coping. When optional hydrotherapy jets are selected, the jets

are plumbed into the rear wall over the bench and the jet’s

pump is located at the front and plugs into the heater/controller.

The radio controlled 5 horsepower Hydraulic Power Unit is

usually located near your electric service. It requires a single 30

amp, 220 volt, GFCI service. A flexible conduit connects this

power unit to the heater/controller

poolside. Hydraulic lines connect between the front of the pool

and the power unit. Up to 25' of hydraulic line is provided

with the pool. Additional hydraulic line may be ordered when

locating the power unit further away.

For fully in-ground installations where the pool is backfilled and

the equipment is kept at the front, a pit needs to be built at the

front of the pool (see drawing on opposite page). While it is

necessary that all fiberglass pools without our optional bracing

system be backfilled at least 18" from the top of the pool, at the

front, to accommodate equipment, a 24" pit may be formed as

shown. The optional Retractable Security Cover typically covers

this pit and a removable lid should be constructed.

Of course this controller/heater/pump system can also be locat-

ed remotely as can the hydrotherapy jets pump. When the

equipment is positioned remotely, water lines will have to run

back and forth to the pool as will the line for the keypad con-

troller. The high efficiency pump will also be replaced with a

pump designed to be self-priming if the water lines run above

the water level. Consult your design representative if you wish to

remotely locate your water quality equipment.

Equipment

1. Skimmer/Filter (50 Square feet)

2. Shut Off Valve

3. Circulating Pump (120 watts)

4. Heater/Controller

5. Inlet to pool

6. Optional Lights

7. Optional Jets Suction Line

8. Optional Jet Pump

9. Hydraulic Power Unit (HPU)

10. Hydraulic Lines (pressure and return)

11. Flexible Conduit from HPU to Heater/Controller

12. Remote Keypad

13. Optional Retractable Security Cover (opposite page)

24"

FRONT ELEVATION