User`s manual

6. Insert and connect the top corner tubes (Part D). It may be
helpful to insert both ends of corner tube into the corresponding
liner sleeves, and then pull back on the corner tube to connect
one end at a time to the top rails (Parts B and C).
7. Ensure that all tubes around the perimeter are completely nest-
ed in one another and properly connected, and that no parts of
the frame are racked or crooked.
8. Slowly begin to fill the pool with water until the bottom of the
liner is almost taught. Remove any wrinkles in the pool liner at
this time, as it will be difficult to do so once there are more than
just a few inches of water in the pool.
9. To prevent leaking issues, it is very important to plumb and
plug both through walls before the water level reaches the two
pre-cut holes in the liner. For more information, refer to the
section in this Owners’ Manual titled, WATER QUALITY
SYSTEM, SKIMMER & THRU-WALL FITTINGS.
10. Once these holes have been plugged, assemble the Fastlane
Swim Unit.
FASTLANE SWIM UNIT ASSEMBLY
1. Verify that all items have arrived. NOTE: If using a power
drill, do NOT over tighten the screws, as this will strip the
thread in the PVC of the Fastlane Swim Unit.
2. Carefully unpack the Swim Unit Housing, Swim Unit Base and
its components from box numbers 10, 11 and 13 (Refer to sec-
tion titled, RECEIVING THE FASTLANE POOL). Remove
and verify all hardware kits from inside. Close the boxes and
flip them upside down on the ground to use as a workbench or
collapse the boxes and use as a smooth surface to protect the
components from scratching.
3. Turn the Swim Unit Housing upside down on the box or anoth-
er smooth surface. Remove the block of wood by
removing the screws that attach the wood to the Swim Unit
Housing. The wood is for packaging purposes only and may be
discarded.
4. Remove the screws on the two sides and the front of the Swim
Unit Housing that secure the throat. Set the throat and the
screws aside to be used in Step 13.
5. Set the Swim Unit Base on the cardboard box with the cylinder
facing up. Lay the hydraulic hoses that come pre-attached to
the Swim Unit Base to each side so that they are out of the way.
Flip the Swim Unit Housing over and set on top of the Swim
Unit Base. Secure the Swim Unit Base to the Swim Unit
Housing by using six of the 1" stainless steel screws provided
(three screws on each side). NOTE: Do not over-tighten.
6. Carefully feed the bond wire that is attached to the Swim Unit
Base up behind the horizontal honeycomb grill located in the
bottom of the Swim Unit Housing and up through the turning
vanes. Install the grab rail using six 3/4" stainless steel screws
5