User`s manual

7) In order to best accommodate the ladder, create a notch meas-

uring 22 1/2" long and 2 1/2" deep in the center (or in a pre-

ferred ladder location) of the final 8'-11" cedar plank. Do not

discard this piece that has been cut out, as it will be later used

to help attach the ladder to the pool deck.

8) Using the 2" deck screws, this plank should then be attached to

the vertical plank at the rear of the pool, so that its back edge

completely covers the vertical plank’s top edge, and it fits neat-

ly between the edges of the two top planks along the sides of

the pool.

9) Using the scrap cedar plank material from when the original

planks were cut, place one end of the drop-off against the edges

of cedar planks at the front (right and left) corners of the pool.

Trace the horizontal top surface along the scrap piece, and cut

the piece so that the angle makes an attractive cover piece for