User`s manual

Daily:
• Test for free chlorine after swimming, or at least a few
times a week.
• Add chlorine to maintain free chlorine levels between 0.5 and
1.5 ppm.
• As one becomes familiar with the chlorine demand for the
Fastlane Pool, the amount of chlorine needed to maintain the
residual at a minimum level of 0.5 ppm will likely become sec-
ond nature, and frequency of needing to test chlorine levels will
likely decrease.
Weekly
• Check and adjust the water level. The water should completely
cover the honeycomb grill where the current is produced. Water
levels greater than 1/2” lower than this can create a choppy cur-
rent and may cause the skimmer to draw air into the plumbing
lines. Having the water level 1” or more higher than that honey-
comb grill can cause more water to splash out of the pool.
• Test the pH level at least twice a week. Broadcast (i.e. pour
chemical into the current) pH increaser or pH decreaser to main-
tain levels between 7.4 and 7.8.
Winterizing the Fastlane Pool
• Take the Fastlane Pool down and/or re-install it indoors if
desired when living in an area where harsh winter weather
occurs.
• “Winterizing” is specific to the climate in which the pool is
located. “Winterizing” generally refers to the treatment of the
water in the pool, draining the pool water below the Fastlane
Swim Unit and draining the equipment, but the pool structure
alone requires no special attention.
• If it is desired to winterize the Fastlane Pool, the water level
must be drained below all wall fittings and below the Fastlane
Swim Unit. Additionally, the plumbing fittings need to be dis-
connected from the pool wall at the respective unions and stored
in a dry and safe place. Be careful not to lose the o-rings of the
unions if doing this.
• If storing the pool, thoroughly clean and dry the liner before
carefully rolling it up.
• Store the pool and Fastlane Swim Unit in a dry safe place. Store
the structural parts separate from the liner (preferably in boxes)
to protect the liner from damage.
• It is okay for the Hydraulic Power Unit to remain outside with
the hydraulic run hoses in the wintertime, as the fluid inside will
not freeze. The hydraulic run hoses will need to be capped, how-
ever, to prevent any fluid from draining out.
• Please contact Endless Pools Customer Service Department at 1-
800-910-2714 with any questions or concerns.
Disassembling the Fastlane Pool
• Unhook the hydraulic hose connections at the Hydraulic Power
Unit and cap all ends to prevent hydraulic fluid from draining.
• Pull the hydraulic hoses through the grommet holes (if applica-
ble) and lift the Fastlane Swim Unit with hanger from the pool
wall. Pull the Fastlane Swim Unit out of the pool carefully so as
not to damage the pool liner fabric.
• Once the pool is drained, reach in each corner pocket and pull
the liner away from the top rail tubes.
• Once the liner is loose from the top rail, walk around the outside
perimeter of the pool moving the wall back and forth to loosen
the top rail and corner pieces.
• Begin disassembling Fastlane Pool by removing the corners
from the structure. Be very careful to slowly pull the corners
from the top rails. Jolting or forcing the corner out of the top
rail can create a tear in the corner of the liner.
• Once the corners are off, lift the top rails off of the struts and
disassemble the remainder of the pool. Be sure the liner is clean
and fully dry before storing.
Water Quality System
Filter
• After 24 hours of filtering following the addition of chlorine,
bleed off any air at the filter and note the pressure (read the pres-
sure gauge) on a test log sheet.
• If the pool has been contaminated with any debris during instal-
lation, it may be desirable to clean or exchange the cartridge fil-
ter at this time.
• Typically, the cartridge should be removed or replaced when the
filter pressure rises 5 psi above the starting pressure.
• For indoor installations with little to moderate use, this may only
be necessary once every few months.
• The filter pressure should be checked every two weeks.
Nature 2 Replacement Instructions
The Nature 2 purifier should be replaced every 3–4 months. One
cartridge will sit in the skimmer basket. Use the small stickers
included in the box on a pool maintenance calendar to note the
necessary change date. Replacement cartridges (after the first set)
can be purchased by calling the Endless Pools Customer Service
Department at 1-800-910-2714, visiting www.myendlesspool.com
or from a local pool store.
PLACARDING THE FASTLANE POOL
Place the included eight no diving into pool/keep children super-
vised at all times stickers on all four sides of the pool, on the
inside and outside top rail area of the liner, before using the
Fastlane Pool.
NO DIVING into the Fastlane Pool.
Please keep children supervised at ALL times!
Endless Pools is an industry leader in customer service.
Please call the Endless Pools Customer Service Department at 1-
800-910-2714 with any questions or inquiries regarding the
Fastlane Pool.
Additional water quality and swimming products are always avail-
able at www.myendlesspools.com
17