User`s manual

the pump foot. Use the provided screws to clamp the pump on the
power unit handle.
Attach the pump union nuts to both fittings of the pump. Make
sure that the o-rings are in place before attaching the union fit-
tings. Glue a male slip x female slip street elbow into the pressure
fitting of the pump so that it is facing away from the power unit.
Cut two 2-1/2” lengths of flexible PVC off of the 50’ roll of flex-
ible PVC that was provided. Glue one of these lengths into the
union fitting connected to the suction side of the pump. Glue the
other length of 2-1/2” PVC into the elbow that is connected to the
pressure union. Next glue a slip x slip ball valve onto each of the
2-1/2” lengths of flexible PVC. Finally, cut the 50’ length down
to the appropriate lengths to connect the suction side of the pump
to the skimmer thru-wall assembly and connect the pressure side
of the pump to the return thru-wall assembly.
ASSEMBLING THE WATER QUALITY SYSTEM
WITH HEATER CONTROLLER
Note: Additional PVC fittings can be found in the Heater
Controller box. Loosely attach the circulating pump to the power
unit. The pump will be attached to the handle of the power unit
on the same side as the hydraulic connections. Place the circulat-
ing pump onto the power unit so that the suction of the circulating
pump is facing out. Place the pump foot clamp onto the underside
of the power unit handle, aligning the holes in the pump foot
clamp to holes in the pump foot. Use the provided screws to
clamp the pump to the power unit handle.
Next remove the two reservoir mounting bolts on the side oppo-
site the power unit controller. Align the holes in the heater con-
troller mounting board with holes in the power unit that were just
removed. Replace the bolts and tighten securely.
Then place the heater controller-mounting clamp onto the mount-
ing board so that they are aligned with the holes closest to the
power unit. The tabs of the mounting clamp should be facing away
from the power unit. There should also be a gap between the tab
and the spacer. Use the provided hardware to attach the mounting
clamp to the mounting board. DO NOT install screws into the
front holes at this time.
Now slide the heater controller into position, so that the plug-in
ports are facing away from the power unit and the feet of the
heater controller are seated firmly under the mounting clamp.
Once the heater controller is in place, use the provided nut and
machine screws to attach the Heater/Controller to the mounting
board.
Pre-cut lengths of PVC have been provided. Apply PVC cleaner
to both faces of the joint prior to gluing for every glue joint. Take
the 6-1/2” long piece of pipe and glue the female end of a male
slip x female slip elbow (street elbow) onto one end and glue a
pump union onto the other. Make sure that the union nut is in place
prior to gluing. Finally, glue a heater controller union half onto
the male end of the street elbow. Once this assembly has been
glued together, connect the pump to the heater controller. Make
sure that there is an o-ring between the pump union and the pump
discharge and there is a T-Gasket between the heater controller
union nut and the union half.
10
Suction
Pressure