User`s manual

User’s Manual 25
․On-Chip Serial ATA
Disabled
Disables the onboard SATA.
Auto
The system will detect the existing SATA and IDE drives
then automatically set them to the available master/slave
mode.
Combined Mode
This option allows you to use both IDE and SATA drives;
allowing a maximum of 4 drives. You must manually set
the SATA drives’ master/slave mode in the “Serial ATA
Port0 Mode” and “Serial ATA Port1 Mode” fields.
Enhanced Mode
This option allows you to use both IDE and SATA drives;
allowing a maximum of 6 drives.
SATA Only
This option automatically sets the SATA drives to Primary
Master and Secondary Master modes. Since both drives are
in master mode, you cannot set the IDE drives to Master
mode. The “Serial ATA Port0 Mode” and “Serial ATA
Port1 Mode” fields will not be configurable.
․
Serial ATA Port0 Mode and Serial ATA Port1 Mode
These fields are used to select the master/slave mode of the serial ATA drives.
Make sure they do not conflict with the settings of the IDE hard drives.
Onboard Device
Item Available Options:
USB Controller Enabled
USB 2.0 Controller Enabled
USB Keyboard Support Enabled
USB Mouse Support Disabled
AC97 Audio Enabled
Onboard LAN Boot ROM Enabled
Onboard CSA LAN Boot ROM Enabled (Optional Item)
CSA LAN (Giga-LAN) Enabled (Optional Item)
26 The ENDAT-4066i System Board
SuperIO Device
Item Available Options:
POWER ON Function Button ONLY
KB Power ON Password Enter
Hot Key Power ON Ctrl-F1
Onboard Serial Port 1 3F8/IRQ4
Onboard Serial Port 2 2F8/IRQ3
UART Mode Select Normal
RxD, TxD Acitve Hi,Lo
IR Transmission Delay Enabled
UR2 Duplex Mode Half
Use IR Pins IR-Rx2Tx2
Onboard Parallel Port 378/IRQ7
Parallel Port Mode SPP
EPP Mode Select EPP1.9
ECP Mode Use DMA 3
PWRON After PWR-Fail Off