Manualshelf

User manual

ManualsBrandsENDA ManualsPanel-Mount InstrumentsProgrammable LED voltmeter EPV141-R ±500 V/AC/DC Assembly dimensions 70 x 29 mm
12345
*
*
Sampling time of the measurement value is shown on the screen. If the 1 selected;sampling time of the measurement is 250ms,
If 2 is selected,it is 500ms.If 3 is selected, it is 750ms.If 1 is selected,it is 1 second.
Optn
If this key is pressed,
measuring type
appears.
By using and keys, measuring type can be adjusted to , or ac dc acdc.Three leds
at the top of the display show measuring type.
Measuring
type
SET
If this key is pressed,
address of the device appears.
Adrs 1
By using and keys address of the device can be adjusted between 1-247.
SET
**
If this key is pressed,
sampling time measurement
value appears.
SET
4
Sampling time
measurement value
ACdC
SET
If key is pressed,it returns to parameter name.
SET
If key is pressed, it returns to parameter name.
SET
If key is pressed, it returns to parameter name.
SET
baud OFF
By using and keys, baudrate value of the device can be adjusted to OFF,1200,2400,4800,9600,19200.
SET
If key is pressed,it returns to parameter name.
(*) There are only
(**)The AdrS and baud parameters are only in the devices those have modbus.
,tYPE, optn, CInp parameters in the devices those have no relay.
If any key is pressed in 25 seconds or the device is powered down and powered upş,then it returns to operation mode.
NOTE:
**
If key is held down while the device is powered up, the d.PAr message will appear and the factory settings will be restored.
Means, measured current value is higher than maximum scale.
Means, measured current value is lower than minimum scale.
ERROR MESSAGES
When this key is pressed,
baudrate is seen.
SET
C.Inp
500
*
When this key is pressed,
measurement input type
s seen.
If C.Inp input type “500” is selected, the measurement terminals 9 and 12 of the terminals must be connected.Otherwise the measurement is done incorrectly.
If Cınp input type “50” is selected, the measurement terminals 10 and 11 of the terminals must be connected.Otherwise the measurement is done incorrectly.
4/5
Factory settings restored after CInp;50,HYSL and HYSU are set to “1.00”
EPV241A-E-02-R-201307