Specifications

7-50 Chapter 7: Maintenance and Troubleshooting
SP201-SA™ Customization and Maintenance Guide
b To stop an ISUP raw message trace for a range of timeslots, type
trace isupmsg
trk1 : ts1 trk2 : ts2 off and press Enter,
where trk1:ts1 represents the range’s beginning trunk and timeslot
and trk2:ts2 represents the ending trunk and timeslot.
c To stop an ISUP raw message trace for all timeslots on a single trunk,
type trace isupmsg
trk off and press Enter.
d To stop an ISUP raw message trace for all timeslots on all trunks,
type trace isupmsg all off and press Enter.
 The ISUP raw message trace is stopped. A message similar to the
following is displayed.
7.2.5.5 The trace Command
Note: The new trace command, in SignalPath software version 1070 and
later, is not a revision of the former trace command; it is a different
command. Please read this section carefully for details.
To use the replacement for the former trace command, see Section 7.2.5.2, The
trace isup Command.
The trace command, available for all protocols, turns on the automated trace
functions available on the SP201-SA. The specific trace functions available
depend on the software in the SP201-SA.
The following sections discuss trace functions that are automated. (Table 7-4
indicates the software in which specific traces are automated.)
• Section 7.2.5.1, The trace cas Command
• Section 7.2.5.2, The trace isup Command
• Section 7.2.5.3, The trace isdnmsg Command
• Section 7.2.5.4, The trace isupmsg Command
Command "trace isupmsg all off" completed